Heater for Cooled Cameras with T2 Thread Connection

Codice articolo: DEWH-6551

The heater prevents dew condensation on the optical window of cooled astro and CCD cameras
♦ Suitable for cooled cameras with T2 connection, for example from Altair or ZWO

♦ Easy attachment to the camera in minutes

♦ Does not change the working distance of the camera

♦ 51 mm inner aperture and 65 mm outer diameter

♦ Suitable for all dew heater controllers, for example from Kendrick or TS-Optics

Installation instructions:
You need a mild glue (such as a thin layer of silicon sealant) to attach the heater against the front of your camera. Silicon is easy to remove by just peeling it off, and it won´t damage the camera front like some heaters which use very sticky compounds which and take the anodising off with it.

Use sparingly. An alternative is to just use electrical tape around the edges which also peels off without much residue.

IMPORTANT: You must ensure the two spade contacts cannot touch each other after installation. They must be insulated by wrapping with electrical tape to avoid short-circuits.

NOTE: Dew heaters must ONLY be connected to a reliable, good quality 12 V dew heater controller with a fuse. NEVER connect ANY dew heater to 12 V direct current power source or mains power under any circumstances, no matter what you read on the Internet.